Request Information
Polypropylene is an economical material that offers a combination of outstanding physical, chemical, mechanical, thermal and electrical properties not found in any other thermoplastic. Compared to low or high density polyethylene, it has a lower impact strength, but superior working temperature and tensile strength. Polypropylene provides excellent resistance to organic solvents, degreasing agents and electrolytic attack. It is lightweight, resistant to staining, and has a low moisture absorption rate. This is a tough, heat-resistant, semi-rigid material, ideal for the transfer of hot liquids or gases. It is recommended for vacuum systems and where higher heats and pressures are encountered. It has excellent resistance to acids and alkalines, but poor resistance to aromatic, aliphatic and chlorinated solvents.
  • ASTM D4101 - FDA Compliant.
  • Other sheet sizes available on request.
  • Length & Width Tolerance : - 0.00"/+ only.
Unit of Measure

Sheet Size

 N/A 12 x 12 in

Thickness

 N/A 2.500 in

Weight

 N/A 11.75 lb/ft²

Density (ASTM D792)

 N/A 0.905 gm/cc

Hardness, Durometer Shore D

 N/A 78

Hardness - Rockwell (ASTM D785)

 N/A R92

Water Absorption (ASTM D570)

 N/A 0.008 %

Tensile Strength at Break (ASTM D638)

 N/A 5150 psi

Tensile Modulus - 73°F (ASTM D638)

 N/A 190240 psi

Elongation - Yield (ASTM D638)

 N/A 11 %

Elongation at Break (ASTM D638)

 N/A 400 %

Flexural Modulus

 N/A 212425 psi

Izod Impact Strength - Notched at 73ºF (ASTM D256)

 N/A 1.9 ft·lb/in

Tensile Impact Strength (DIN 53448)

 N/A 269 ft·lb/in²

Coefficient of Linear Thermal Expansion

 N/A 4.3 x 10-5 in/in/ºF

Heat Deflection Temperature at 66 psi

 N/A 210 ºF

Maximum Operating Temperature

 N/A 180 ºF

Flammability Rating (UL 94)

 N/A HB

Volume Resistivity (ASTM D257)

 N/A > 1015 ohm·cm> 1015 ohm

Optional Sheet Size

 N/A 12 x 24 12 x 36 24 x 120 24 x 24 24 x 96 36 x 48 48 x 48 48 x 72 60 x 120

N/A

  • Chemical Resistant Tanks & Linings.
  • Laboratory Consoles.
  • Sinks & Ducts.
  • Plating Barrels & Tanks.
  • Pump Components & Housings.
  • Prosthetic Devices.
  • Die Cutting Pads.
  • Clean Room Walls, Floors & Ceilings.

N/A

  • FDA / USDA Compliant (Natural).
  • Lightweight.
  • High Tensile Strength.
  • Impact Resistant.
  • High Compressive Strength.
  • Non-Toxic.
  • Low Moisture Absorption.
  • Excellent Electrical Properties.