Print Back
Polypropylene is an economical material that offers a combination of outstanding physical, chemical, mechanical, thermal and electrical properties not found in any other thermoplastic. Compared to low or high density polyethylene, it has a lower impact strength, but superior working temperature and tensile strength. Polypropylene provides excellent resistance to organic solvents, degreasing agents and electrolytic attack. It is lightweight, resistant to staining, and has a low moisture absorption rate. This is a tough, heat-resistant, semi-rigid material, ideal for the transfer of hot liquids or gases. It is recommended for vacuum systems and where higher heats and pressures are encountered. It has excellent resistance to acids and alkalines, but poor resistance to aromatic, aliphatic and chlorinated solvents.
  • ASTM D4101 - FDA Compliant.
  • 0.125" through 2.50" diameter available in full lengths only. 2.500" diameter through 14.00" diameter sold in foot increments.
Unit of Measure

Specifications

Weight

N/A 14.000 lb/ft

Density (ASTM D792)

N/A 0.905 gm/cc

Hardness, Durometer Shore D

N/A 78

Hardness - Rockwell (ASTM D785)

N/A R92

Water Absorption (ASTM D570)

N/A 0.008 %

Tensile Strength at Break (ASTM D638)

N/A 5150 psi

Tensile Modulus - 73°F (ASTM D638)

N/A 190240 psi

Elongation - Yield (ASTM D638)

N/A 11 %

Elongation at Break (ASTM D638)

N/A 400 %

Flexural Modulus

N/A 212425 psi

Izod Impact Strength - Notched at 73ºF (ASTM D256)

N/A 1.9 ft·lb/in

Tensile Impact Strength (DIN 53448)

N/A 269 ft·lb/in²

Coefficient of Linear Thermal Expansion

N/A 4.3 x 10-5 in/in/ºF

Heat Deflection Temperature at 66 psi

N/A 210 ºF

Maximum Operating Temperature

N/A 180 ºF

Flammability Rating (UL 94)

N/A HB

Volume Resistivity (ASTM D257)

N/A > 1015 ohm·cm> 1015 ohm

Standard Length

N/A 10 ft4 ft8 ft

Applications

N/A

  • Chemical Resistant Tanks & Linings.
  • Laboratory Consoles.
  • Sinks & Ducts.
  • Plating Barrels & Tanks.
  • Pump Components & Housings.
  • Prosthetic Devices.
  • Die Cutting Pads.
  • Clean Room Walls, Floors & Ceilings.

Characteristics

N/A

  • FDA / USDA Compliant (Natural).
  • Lightweight.
  • High Tensile Strength.
  • Impact Resistant.
  • High Compressive Strength.
  • Non-Toxic.
  • Low Moisture Absorption.
  • Excellent Electrical Properties.